Configuration 编辑
After you have installed the SD-WAN software and licenses, you can configure SD-WAN appliance settings to start managing your network and deployment.
The SD-WAN appliance configuration includes the following:
Configure MCN: The MCN serves as the distribution point for the initial system configuration and any subsequent configuration changes. You perform most upgrade procedures through the Management Web Interface on the MCN. There can be only one active MCN in a Virtual WAN. By default, appliances have the pre-assigned role of client. To establish an appliance as the MCN, you must first add and configure the MCN site, and then stage and activate the configuration and appropriate software package on the designated MCN appliance.
Configure Branch: The procedure for adding a branch site is similar to creating and configuring the MCN site. However, some of the configuration steps and settings do vary slightly for a branch site. In addition, once you have added an initial branch site, for sites that have the same appliance model you can use the Clone (duplicate) feature to streamline the process of adding and configuring those sites. As with creating the MCN site, to set up a branch site you must use the Configuration Editor in the Management Web Interface on the MCN appliance. The Configuration Editor is available only when the interface is set to MCN Console mode.
Configure virtual path between MCN and branch sites: Configure the Virtual Path Service between the MCN and each of the client (branch) sites. To do this, you use the configuration forms and settings available in the Connections section configuration tree of the Configuration Editor.
Enable and configure WAN optimization: The section provides step-by-step instructions for enabling and configuring SD-WAN Premium (Enterprise) Edition WAN Optimization features for your Virtual WAN. To do this, you use the Optimization section forms in the Configuration Editor of the Web Management Interface on the MCN.
NOTE
Citrix SD-WAN Orchestrator services do not support IPv6 addresses.
The following features of Citrix SD-WAN appliances support IPv6 address from Citrix SD-WAN 11.3 release:
Management plane features
- Management interface
- RADIUS server
- TACACS+ server
- SMTP server
- Syslog server
- HTTP server
- DNS server
- App Flow/IPFIX
- SNMP
- Remote licensing
- Centralized licensing
- NTP server
- Allow list
- New User Interface for SD-WAN appliances
- Diagnostics
NOTE
After configuring the above listed features with management IPv6 address, if you disable IPv6 protocol under Appliance Settings > Network Adapters, then the features do not work as expected.
Data plane features
NOTE
IPv6 addresses are not supported on Citrix Citrix SD-WAN 1000 SE / PE, Citrix SD-WAN 2000 SE / PE, and Citrix SD-WAN 4000 SE appliances.
IPv6 addresses are not supported in the following configurations:
- Dynamic Routing (OSPF/BGP)
- Virtual Router redundancy protocol
- Premium edition or Two-Box support
- Cloud direct
- VNF/3rd Party Firewall
- Netflow
- Header compression for IPv6 packets
- Application Routing
- Office-365 support
- Prefix delegation group
如果你对这篇内容有疑问,欢迎到本站社区发帖提问 参与讨论,获取更多帮助,或者扫码二维码加入 Web 技术交流群。
绑定邮箱获取回复消息
由于您还没有绑定你的真实邮箱,如果其他用户或者作者回复了您的评论,将不能在第一时间通知您!
发布评论