Install Linux Virtual Delivery Agent for Debian

You can choose to follow the steps in this article for manual installation or use easy install for automatic installation and configuration. Easy install saves time and labor and is less error-prone than the manual installation.

Note:

Use easy install only for fresh installations. Do not use easy install to update an existing installation.

Step 1: Prepare Debian for VDA installation

Step 1a: Verify the network configuration

We recommend that the network is connected and configured correctly before proceeding.

Step 1b: Set the host name

To ensure that the host name of the machine is reported correctly, change the /etc/hostname file to contain only the host name of the machine.

hostname

Step 1c: Assign a loopback address to the host name

Ensure that the DNS domain name and Fully Qualified Domain Name (FQDN) of the machine are reported back correctly. The way is to change the following line of the /etc/hosts file to include the FQDN and host name as the first two entries:

127.0.0.1 hostname-fqdn hostname localhost

For example:

127.0.0.1 vda01.example.com vda01 localhost

Remove any other references to hostname-fqdn or hostname from other entries in the file.

Note:

The Linux VDA currently does not support NetBIOS name truncation. Therefore, the host name must not exceed 15 characters.

Tip:

Use a–z, A–Z, 0–9, and hyphen (-) characters only. Avoid underscores (_), spaces, and other symbols. Do not start a host name with a number and do not end with a hyphen. This rule also applies to Delivery Controller host names.

Step 1d: Check the host name

Verify that the host name is set correctly:

hostname
<!--NeedCopy-->