Use configuration templates to create audit templates

You can now use configuration commands that were previously saved as configuration templates to create Audit Templates that can be applied to specific NetScaler instances. While creating an audit template, you can drag and drop previously saved configuration templates into the Commands field, and edit the template to suit your requirements. You can then apply the audit template to specific NetScaler instances. Citrix ADM compares these instances with the audit template and reports any mismatch. This process helps you identify errors and rectify them in a timely manner.

You can create configuration templates while creating a new job and saving a set of configuration commands as a template. When you save these templates on the Create Jobs page, they are automatically displayed on the Create Template page.

For example, consider a basic load balancing configuration for which you add a load balancing virtual server, add two services, and bind the services to the virtual server.

This example uses the following commands:

add lb vserver servername HTTP ipaddress portnumber

add service servicename1 ipaddress1 HTTP 80

add service servicename2 ipaddress2 HTTP 80

bind lb vserver servername servicename1

bind lb vserver servername servicename2

To save a configuration template in Citrix ADM:

1. Navigate to Networks > Configuration Jobs, and click Create Job.

2. On the Create Job page, specify the job name and the instance type.

3. Choose Configuration Template as the Configuration Source and, in the Commands field, enter commands such as those in the above example.

4. Select the Save as Configuration Template checkbox and specify a name for your template. You can choose to overwrite other templates that exist with the same name.

5. Click Save.

   

To use a configuration template to create an audit template in Citrix ADM:

1. Navigate to Networks > Configuration Audit > Audit Templates, and click Add.

2. On the Create Template page, specify a name for the template name, and enter a description.

3. From the Configuration Source list, select Configuration Template, and then drag and drop the template into the Commands field in the right pane. You can also edit the configuration and save the template with a different name. Click Next.

4. On the Select Instances tab, click Add Instances and add the instances on which you want to run the configuration. Click OK.

5. Click Finish.

   

The audit template appears in the Audit Templates list and is run every 12 hours against the configurations of the specified instances.