Internet Protocol version 6 (IPv6) 编辑
A Citrix ADC appliance supports both server-side and client-side IPv6 and can therefore function as an IPv6 node. It can accept connections from IPv6 nodes (both hosts and routers) and from IPv4 nodes, and can perform Protocol Translation (RFC 2765) before sending traffic to the services.
The following table lists some of the IPv6 features that the Citrix ADC appliance supports.
Table 1. Some Supported IPv6 Features
| IPv6 features |
|---|
| IPv6 addresses for SNIPs (NSIP6, VIP6, and SNIP6) |
| Neighbor Discovery (Address Resolution, Duplicated Address Detection, Neighbor Unreachability Detection, Router Discovery) |
| Management Applications (ping6, telnet6, ssh6) |
| Static Routing and Dynamic routing (OSPF, BGP, RIPng, and ISIS) |
| Port Based VLANs |
| Access Control Lists for IPv6 addresses (ACL6) |
| IPv6 Protocols (TCP6, UDP6, ICMP6) |
| Server Side Support (IPv6 addresses for vservers, services) |
| USIP (Use source IP) and DSR (Direct Server Return) for IPv6 |
| SNMP and CVPN for IPv6 |
| HA with native IPv6 node address |
| IPv6 addresses for MIPs |
| Path-MTU discovery for IPv6 |
Implementing IPv6 Support
You must enable IPv6 feature on a Citrix ADC appliance before you can use or configure it. If IPv6 is disabled, the Citrix ADC does not process IPv6 packets. It displays the following warning when you run an unsupported command:
"Warning: Feature(s) not enabled [IPv6PT]"
<!--NeedCopy-->
如果你对这篇内容有疑问，欢迎到本站社区发帖提问 参与讨论，获取更多帮助，或者扫码二维码加入 Web 技术交流群。
绑定邮箱获取回复消息
由于您还没有绑定你的真实邮箱，如果其他用户或者作者回复了您的评论，将不能在第一时间通知您！
发布评论