Set up basic load balancing 编辑

Before configuring your initial load balancing setup, enable the load balancing feature. Then begin by creating at least one service for each server in the load balancing group. With the services configured, you are ready to create a load balancing virtual server, and bind each service to the virtual server. That completes the initial setup. Before proceeding with further configuration, verify your configuration to make sure that each element was configured properly and is operating as expected.

Enabling Load Balancing

You can configure load balancing entities such as services and virtual servers when the load balancing feature is disabled, but they will not function until you enable the feature.

To enable load balancing by using the CLI

At the command prompt, type the following command to enable load balancing and verify the configuration:

• enable ns feature LB
• show ns feature

Example

    > enable ns feature LoadBalancing

     Done

    > show ns feature



            FeatureAcronym              Status

            --------------              ------

     1)     Web Logging    WL   OFF

     2)     Surge Protection               SP   ON

     3) Load Balancing LB ON

     .

     .

     .

     24)    NetScaler Push push OFF

     Done
<!--NeedCopy-->