在EKS上安装Kong API网关

发布于 2025-02-07 21:32:00 字数 943 浏览 3 评论 0原文

按照

time="2022-06-15T19:14:52Z" level=info msg="successfully synced configuration to kong."
time="2022-06-15T19:14:54Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"
time="2022-06-15T19:14:57Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"
time="2022-06-15T19:15:00Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"

最后一行重复每3秒）

...而同一POD内的代理容器失败，

2022/06/15 19:47:27 [error] 1110#0: *11302 [lua] api_helpers.lua:511: handle_error(): /usr/local/share/lua/5.1/lapis/application.lua:424: /usr/local/share/lua/5.1/kong/api/routes/health.lua:45: http2 requests not supported yet

我没有对值文件进行任何自定义，我只是只是默认情况下安装。这些说明（只是“ Helm Repo Add”和“ Helm install”）来自官方网站，所以什么是不对劲？ Helm为v3.8，K8S为v1.21。

原文

Following the super-simple instructions in this link (the helm method) I'm trying to install Kong on an test EKS cluster (in an empty kong namespace) and it's a disaster. The service never gets an external IP (stuck at "pending"). The ingress-controller container inside the main pod fails with:

time="2022-06-15T19:14:52Z" level=info msg="successfully synced configuration to kong."
time="2022-06-15T19:14:54Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"
time="2022-06-15T19:14:57Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"
time="2022-06-15T19:15:00Z" level=error msg="checking config status failed: %!w(*kong.APIError=&{500 An unexpected error occurred})"

(the last line repeating every 3sec)

...while the proxy container inside the same pod fails with repeating

2022/06/15 19:47:27 [error] 1110#0: *11302 [lua] api_helpers.lua:511: handle_error(): /usr/local/share/lua/5.1/lapis/application.lua:424: /usr/local/share/lua/5.1/kong/api/routes/health.lua:45: http2 requests not supported yet

I'm not doing any customizing with the values file, I'm just installing as it comes by default. The instructions (just a "helm repo add" and a "helm install") come from the official Kong site, so what is amiss?? Helm is v3.8, K8s is v1.21.

分享到QQ

分享到微博