PerformancePoint 仪表板设计器创建筛选器时出错 - 未检索到筛选器数据
我正在尝试使用 PerformancePoint 的仪表板设计器创建过滤器。然而，完成向导后，“确认”页面会显示以下消息：
未检索到过滤器数据
警告 1：过滤器已创建，但没有创建 数据已检索。为了解决 出现问题，请按照以下步骤操作。 1. 验证此过滤器的数据源配置是否正确。 2. 检查服务器事件日志。有关此的附加信息 问题可能已被记录。
数据源很好...我使用数据源构建了过滤器应该过滤的报告...报告没有问题。
至于日志，唯一令人不安的地方是从 PerformancePoint 服务器（SharePoint 组的一部分）调用 SQL Server 时 - PerformancePoint 服务器上的事件查看器有一条很长的消息，其中重要部分是“现有连接被远程主机强制关闭。”
还有其他人在使用 PerformancePoint 中的筛选器时遇到过问题吗？
I'm attempting to create a filter using PerformancePoint's Dashboard Designer. After going through the wizard, however, the "Confirmation" page displays the following message:
No filter data retrieved
Warning 1: Filter was created but no
data was retrieved. To resolve the
problme, follow the step(s) below.
1. Verify that the data source for this filter is configured properly.
2. Check the server event log. Additional information about this
problem may have been recorded.
The data source is fine... I used the data source to build the report that the filter is supposed to be filtering... no problems with the report.
As for the logs, the only troubling spot is when the call is made from the PerformancePoint server (part of the SharePoint group) to the SQL Server -- the Event Viewer on the PerformancePoint server has a long message of which the important part is "An existing connection was forcibly closed by the remote host."
Has anyone else had trouble with Filters in PerformancePoint?
如果你对这篇内容有疑问，欢迎到本站社区发帖提问 参与讨论，获取更多帮助，或者扫码二维码加入 Web 技术交流群。
绑定邮箱获取回复消息
由于您还没有绑定你的真实邮箱，如果其他用户或者作者回复了您的评论，将不能在第一时间通知您！
发布评论
评论（1）
这是由 Kerberos 校验和机制的限制引起的，这会终止 MDX 查询。 Microsoft 发布了针对此问题的修补程序：http://support.microsoft.com/kb/969083
This was caused by a limitations in the checksum mechanism for Kerberos which would kill MDX queries. Microsoft released a hotfix for this issue: http://support.microsoft.com/kb/969083