将此 /etc/snmp/snmpd.conf
com2sec paranoid default public #com2sec readonly default public #com2sec readwrite default private
部分更改为：
#com2sec paranoid default public com2sec readonly 127.0.0.1 public #com2sec readwrite default private
重新启动 snmpd：
sudo /etc/init.d/snmpd restart
然后尝试以下一项：
snmpwalk -c public -v 2c 127.0.0.1 .
Change this /etc/snmp/snmpd.conf
part to:
Restart snmpd:
Then try this one:
假设它使用 snmpd，请检查配置文件： /etc/snmpd/snmpd.conf
SNMPD 支持更有限的监控，例如磁盘使用阈值。 可能还有更多选择，我没有经常用它来监控机器。
显然您还可以使用安装程序：
snmpconf -g basic_setup
它会提示您输入信息并为您配置系统。
祝你好运。
Assuming it's using snmpd, check the config file: /etc/snmpd/snmpd.conf
SNMPD supports more limited monitoring like a disk usage threshold. There might be more options, I haven't monitored machines with it a lot.
Apparently you can also use the setup program:
It will prompt you for information and configure the system for you.
Good luck.
由于您还没有绑定你的真实邮箱，如果其他用户或者作者回复了您的评论，将不能在第一时间通知您！
暂无简介
文章 0 评论 0
接受
发布评论
评论（2）
将此 /etc/snmp/snmpd.conf
部分更改为：
重新启动 snmpd：
然后尝试以下一项：
Change this /etc/snmp/snmpd.conf
part to:
Restart snmpd:
Then try this one:
假设它使用 snmpd，请检查配置文件： /etc/snmpd/snmpd.conf
SNMPD 支持更有限的监控，例如磁盘使用阈值。 可能还有更多选择，我没有经常用它来监控机器。
显然您还可以使用安装程序：
它会提示您输入信息并为您配置系统。
祝你好运。
Assuming it's using snmpd, check the config file: /etc/snmpd/snmpd.conf
SNMPD supports more limited monitoring like a disk usage threshold. There might be more options, I haven't monitored machines with it a lot.
Apparently you can also use the setup program:
It will prompt you for information and configure the system for you.
Good luck.