mac下通过vagrant box add添加centos7发生ssh认证出错，但是安装ubuntu时却是正常的，这是为何？

Question

☁  centos7  vagrant reload
==> default: Attempting graceful shutdown of VM...
    default: Guest communication could not be established! This is usually because
    default: SSH is not running, the authentication information was changed,
    default: or some other networking issue. Vagrant will force halt, if
    default: capable.
==> default: Forcing shutdown of VM...
==> default: Clearing any previously set forwarded ports...
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
    default: Adapter 1: nat
==> default: Forwarding ports...
    default: 22 (guest) => 2222 (host) (adapter 1)
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
    default: SSH address: 127.0.0.1:2222
    default: SSH username: vagrant
    default: SSH auth method: password
    default: Warning: Remote connection disconnect. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying...
    default: Warning: Authentication failure. Retrying..

Answer 1

真是日了狗了，现在又自动好了

☁  Centos-7  vagrant up
Bringing machine 'default' up with 'virtualbox' provider...
==> default: Clearing any previously set forwarded ports...
==> default: Clearing any previously set network interfaces...
==> default: Preparing network interfaces based on configuration...
    default: Adapter 1: nat
==> default: Forwarding ports...
    default: 22 (guest) => 2222 (host) (adapter 1)
==> default: Running 'pre-boot' VM customizations...
==> default: Booting VM...
==> default: Waiting for machine to boot. This may take a few minutes...
    default: SSH address: 127.0.0.1:2222
    default: SSH username: vagrant
    default: SSH auth method: password
==> default: Machine booted and ready!
==> default: Checking for guest additions in VM...
    default: No guest additions were detected on the base box for this VM! Guest
    default: additions are required for forwarded ports, shared folders, host only
    default: networking, and more. If SSH fails on this machine, please install
    default: the guest additions and repackage the box to continue.
    default:
    default: This is not an error message; everything may continue to work properly,
    default: in which case you may ignore this message.
==> default: Rsyncing folder: /Users/zhangwei/Vagrant/Centos-7/ => /vagrant
==> default: Machine already provisioned. Run `vagrant provision` or use the `--provision`
==> default: flag to force provisioning. Provisioners marked to run always will still run.