请问，rx2660怎么进入内置raid配置环境，谢谢！

Question

本帖最后由 lzgscott 于 2010-04-13 23:50 编辑

rx2660怎么进入内置raid配置环境，谢谢！
还有，怎么在操作系统中查看硬盘的串号，diskinfo好像看不到

Answer 1

内置RAID的话是使用LSI SAS1068的芯片，正如4楼所说，可以在EFI Shell那里使用drvcfg进入配置环境，在HPUX系统里面的话可以使用sasmgr命令查看或配置~~

P400P800那些才是POST过程中按Shift+8(F8快捷键)进入相应的配置界面~当然，Windows的话使用ACU也可以在图形界面里配置~

Answer 2

好像是F1 F6 记不清了

Answer 3

谢谢，知道了！

Answer 4

已经做了raid了。操作系统看不到了。就像你在操作系统里面看不到存储上盘的信息一样。

进入RAID的设置环境，得先到EFI模式下然后用drvcfg命令来配置。

Answer 5

Using ORCA (IA Platforms Only)
This section describes how to use ORCA, a simple ROM-based configuration utility that runs on all Integrity
Servers. For IA or Integrity systems follow this procedure:
Configuring Your Logical Boot Drive
When using an HP Smart Array controller as your boot controller, use the Option Rom Configuration for
Arrays (ORCA) utility to configure your logical boot drive. The ORCA utility can only be accessed when the
system is booting.
Step 1. Press the F8 key when the prompt appears on the screen during boot to start ORCA and configure
your logical boot drive.
Step 2. Select the Create Logical Drive
Step 3. Use the Arrow keys, Spacebar, and Tab key to navigate around the screen and set up the logical
drive, including an online spare drive if one is required.
NOTE You cannot use ORCA to configure one spare drive to be shared among several
arrays.
Step 4. Press the Enter key to accept the settings
Step 5. Press the F8 key to confirm the settings and save the new configuration. After several seconds, the
Configuration Saved screen is displayed.
NOTE Pressing F8 at the ORCA prompt may not start ORCA on all terminals. If ORCA does not start
when F8 is pressed, reboot and use esc 8 at ORCA prompt to start ORCA.

Answer 6

还有，怎么在操作系统中查看硬盘的串号，diskinfo好像看不到