Question

主题	描述
A.7.5.1 System timing check commands	system_timing_check ::= $setup_timing_check | $hold_timing_check | $setuphold_timing_check | $recovery_timing_check | $removal_timing_check | $recrem_timing_check | $skew_timing_check | $timeskew_timing_check | $fullskew_timing_check | $period_timing_check | $width_timing_check | $nochange_timing_check $setup_timing_check ::= $setup ( data_event , reference_event , timing_check_limit [ , [ notifier ] ] ) ; $hold_timing_check ::= $hold ( reference_event , data_event , timing_check_limit [ , [ notifier ] ] ) ; $setuphold_timing_check ::= $setuphold ( reference_event , data_event , timing_check_limit , timing_check_limit [ , [ notifier ] [ , [ stamptime_condition ] [ , [ checktime_condition ] [ , [ delayed_reference ] [ , [ delayed_data ] ] ] ] ] ]... more
A.7.5.2 System timing check command arguments	checktime_condition ::= mintypmax_expression controlled_reference_event ::= controlled_timing_check_event data_event ::= timing_check_event delayed_data ::= terminal_identifier | terminal_identifier [ constant_mintypmax_expression ] delayed_reference ::= terminal_identifier | terminal_identifier [ constant_mintypmax_expression ] end_edge_offset ::= mintypmax_expression event_based_flag ::= constant_expression notifier ::= variable_identifier reference_event ::= timing_check_event remain_active_flag ::= constant_mintypmax_expression stamptime_condition ::= mintypmax_expression start_edge_offset ::= mintypmax_expression threshold ::=constant_expression timing_check_limit ::= expression
A.7.5.3 System timing check event definitions	timing_check_event ::= [timing_check_event_control] specify_terminal_descriptor [ &&& timing_check_condition ] controlled_timing_check_event ::= timing_check_event_control specify_terminal_descriptor [ &&& timing_check_condition ] timing_check_event_control ::= posedge | negedge | edge_control_specifier specify_terminal_descriptor ::= specify_input_terminal_descriptor | specify_output_terminal_descriptor edge_control_specifier ::= edge [ edge_descriptor { , edge_descriptor } ] edge_descriptor1 ::= 01 | 10 | z_or_x zero_or_one | zero_or_one z_or_x zero_or_one ::= 0 | 1 z_or_x ::= x | X | z | Z timing_check_condition ::= scalar_timing_check_condition | ( scalar_timing_check_condition ) scalar_timing_check_condition ::= expression | ~ expression | expression == scalar_constant | expression === scalar_constant | expression != scalar_constant | expression !== scalar_constant scalar_constant ::= 1’b0 | 1’b1 | 1’B0 |... more